>

MOT History from tests of petrol HONDA CB1s year 1989

Review the list of common HONDA CB1 failures below or to perform a specific mot history check on your HONDA then use our popular KnowYourCar service

mot history
Pass percent:74.74%
(The average a petrol HONDA CB1 year 1989 passes without issue)
Based on:760 MOT Tests
Most common failuresNo# failures
Headlamp aim out of alignment41
Rear reflector on motorcycle missing |1.4.1|14
Front Stop lamp does not illuminate immediately a brake applies |1.3.1a|11
Throttle operating incorrectly |6.2.1f|9
Registration plate issues8
Rear wheel bearings have excessive free play |2.4.A.2c|6
Horn not working |1.7.3a|6
Front wheel bearings have excessive free play |2.3.5b|6
Stop lamp does not illuminate immediately a brake applies |1.3.1a|6
Offside Front shock absorber seal failed and leaking oil |2.3.3|6
Rear Rear wheel bearings have excessive free play |2.4.A.2c|5
Steering movement excessively `notchy` with the weight on the lower bearing |2.2.1a|5
Front Roller brake test indicates a binding brake |3.3.A1a|5
Front Front wheel bearings have excessive free play |2.3.5b|5
Rear Drive chain excessively loose |6.2.1d|4
Rear Rear shock absorber has inadequate damping effect. |2.4.A.3b|4
Rear position lamp does not illuminate immediately when it is switched on |1.1.3a|4
Nearside Front shock absorber seal failed and leaking oil |2.3.3|4
Offside Front Footrest insecure |6.2.1a|4
Front wheel bearings are excessively rough |2.3.5b|4
Front Front wheel bearings are excessively rough |2.3.5b|4
Drive chain worn to excess |6.2.1e|4
Roller brake test No brake control achieves an efficiency of 30%. |3.3.A2a|4
Rear Stop lamp does not illuminate immediately a brake applies |1.3.1a|4
Wheel alignment incorrect which adversely affects the steering |2.5.1|3
Front Steering headbearing has excessive free play |2.2.2|3
Rear Rear reflector on motorcycle missing |1.4.1|3
Drive chain excessively tight |6.2.1d|3
Rear Roller brake test indicates a severely grabbing brake |3.3.A1b|3
Steering movement excessively `notchy` with the wheel raised |2.2.1b|3
Steering control has Insufficient clearance at full lock affecting the riders grasp of handlebars |2.1.2b|3
Offside Front Front shock absorber seal failed and leaking oil |2.3.3|3
Drive chain excessively loose |6.2.1d|3
Nearside Handlebar handgrip not secure to handlebars. |2.1.1c|3
Headlamp aim beam image kick up to the offside |1.6|3
Headlamp insecure |1.2.3b|3
Front Brake disc|s| excessively worn |3.2.A1l|3
Headlamp at least one does not illuminate on dipped beam |1.2.2a|i||3
Nearside Rear Direction indicator not working |1.5.1c|3
Rear Roller brake test indicates a binding brake |3.3.A1a|3
Front suspension has inadequate damping effect. |2.3.6c|3
Front Wheel has an excessively distorted bead rim. |4.2.2|3
Rear shock absorber has inadequate damping effect. |2.4.A.3b|3
Front Horn not working |1.7.3a|2
Front Steering control has Insufficient clearance at full lock affecting the riders grasp of handlebars |2.1.2b|2
Rear Stop lamp does not emit a steady light |1.3.1b|2
Handlebar deformed |2.1.1b|2
Nearside Rear Direction indicator missing |1.5.1a|2
Offside Rear Direction indicator not working |1.5.1c|2
Front shock absorber seal failed and leaking oil |2.3.3|2
Front Exhaust mounting does not fully support the exhaust system |7.1.1.c|2
Direction indicators flashing more than 120 times per minute |1.5.1c|2
Offside Front Steering lock stop ineffective |2.1.3|2
Centre Rear reflector on motorcycle missing |1.4.1|2
Exhaust mounting does not fully support the exhaust system |7.1.1.c|2
Wheel alignment incorrect which adversely affects the handling |2.5.1|2
An item not tested |Manual|2
Nearside Front Front shock absorber seal failed and leaking oil |2.3.3|2
Nearside Rear Direction indicators not working |1.5.1c|2
Front Brake disc|s| is excessively distorted |3.2.A1m|2
Offside Front Shock absorber has a serious fluid leak (5.3.2 (b))2
Front Front shock absorber seal failed and leaking oil |2.3.3|2
Front Floor brake test indicates a binding brake |3.3.C2c|2
Offside Handlebar deformed |2.1.1b|2
Front Stop lamp remains on when the brake is released |1.3.1e|2
Locking device|s| not correctly fitted which may make the motor bicycle dangerous to ride |6.2.1h|2
Rear Brake disc|s| excessively worn |3.2.A1l|2
Roller brake test Neither brake control achieves an efficiency of 25% |3.3.A2b|2
Nearside Front Motorcycle structure excessively damaged |6.1.1a|1
Nearside Front Direction indicator deteriorated and function impaired |1.5.3a|1
Front Front suspension assembly component loose |2.3.1|1
Offside Front Footrest missing |6.2.1a|1
Nearside Rear Direction indicator damaged and function impaired |1.5.3a|1
Front Wheel bearing rough when rotated (5.1.3 (b) (i))1
Nearside Direction indicators flashing more than 120 times per minute |1.5.1c|1
Offside Rear Brake hose is likely to be fouled or trapped by moving parts |3.2.B2c|1
Nearside Front Handlebar grip insecure to handlebar (2.2.1 (d) (ii))1
Nearside Rear Footrest missing |6.2.1a|1
Rear Brake reaction bracket securing bolt|s| loose |3.2.A1j|1
Rear Brake component has restricted free movement and operation is likely to be impeded |3.2.A1h|1
Front Brake cylinder leaking hydraulic fluid |3.2.B1e|1
Front Brake hose leaking fluid |3.2.B4|1
Front Headlamp aim beam image kick up to the offside |1.6|1
Nearside Front Shock absorber has a serious fluid leak (5.3.2 (b))1
Front Stop lamp not working (4.3.1 (a) (ii))1
Rear Stop lamp lens defective such that the emitted light is adversely affected (4.3.1 (b) (ii))1
Front Brake disc contaminated (1.1.14 (b))1
Rear Brake pedal cannot be applied smoothly |3.1.3d|1
Rear Roller brake test indicates a sticking brake |3.3.A1a|1
Nearside Front Direction indicator not working |1.5.1c|1
Exhaust mounting missing |7.1.1c|1
Front Brake master cylinder leaking hydraulic fluid |3.2.B1e|1
Brake lever cannot be applied smoothly |3.1.3d|1
Brake lever has inadequate reserve travel |3.1.3b|1
Stop lamp insecure |1.3.3b|1
Front Brake pipe union leaking fluid |3.2.B4|1
Chain guard fouling another component |6.2.1c|1
Rear Exhaust mounting does not fully support the exhaust system |7.1.1.c|1
Front Brake disc|s| has excessive run out |3.2.A1m|1
Offside Front Brake component damaged and seriously reduced in strength |3.2.A1|1
Steering headbearing has excessive free play |2.2.2|1
Front Brake fluid reservoir fluid level dangerously low |3.2.B1d|1
Headlamp switch faulty |1.2.4|1
Roller brake test The less effective brake control does not achieve an efficiency of 25%. |3.3.A2b|1
Offside Front Direction indicators not working |1.5.1c|1
Offside Rear Footrest missing |6.2.1a|1
Rear shock absorber seal failed and leaking oil |2.4.A.1c|1
Front Roller brake test indicates excessive fluctuation of brake effort |3.3.A1d|1
Rear Brake component is fractured |3.1.5|1
Front Brake caliper|s| securing bolt|s| loose |3.2.A1j|1
Front Shock absorber likely to become detached |5.3.2 |a| |ii||1
Front Wheel bearing rough when rotated |5.1.3 |b| |i||1
Nearside Rear Footrest insecure |6.2.1a|1
Stop lamp remains on when the brake is released |1.3.1e|1
Rear wheel rotation likely to be impeded |6.2.1b|1
Front Wheel alignment incorrect which adversely affects the handling |2.5.1|1
Front Wheel alignment incorrect which adversely affects the steering |2.5.1|1
Offside Front Brake disc|s| friction surface contaminated by oil or grease |3.2.A1k|1
Rear An item not tested |Manual|1
Rear suspension fouling which affects the movement of the rear suspension |2.4.A.3a|1
Nearside Locking devices not correctly fitted which may make the motor bicycle dangerous to ride |6.2.1h|1
Exhaust is leaking and excessively noisey |7.1.1b|1
Seat insecure |6.2.1a|1
Rear reflector missing (4.8.2 (a) (ii))1
Front Wheel bearing has excessive play |5.1.3 |a| |i||1
Offside Rear Stop lamp does not illuminate immediately a brake applies |1.3.1a|1
Offside Steering control has Insufficient clearance at full lock affecting the riders grasp of handlebars |2.1.2b|1
Brake lever attachment screws loose |3.1.2b|1
Rear Drive chain sprocket worn to excess |6.2.1e|1
Rear wheel has a loose wheel nut|s| |4.2.3a|1
Front Floor brake test indicates a sticking brake |3.3.C2c|1
Offside Rear Exhaust mounting does not fully support the exhaust system |7.1.1.c|1
Offside Exhaust noise is clearly in excess of that emitted by a similar motor bicycle fitted with a standard silencer in average condition |7.1.2|1
Drive chain excessively tight |6.1.7 |k| |i||1
Floor brake test indicates a sticking brake |3.3.C2c|1
Front Brake lever is so short and the brake cannot be readily applied |3.1.3c|1
Offside Front Direction indicator not working |1.5.1c|1
Offside Front Shock absorber has a serious fluid leak |5.3.2 |b||1
Centre Rear Rear reflector on motorcycle missing |1.4.1|1
Front Position lamp not working |4.2.1 |a||1
Fuel system component leaking |7.2.1a|1
Handlebar mounting clamp bolt loose |2.1.1a|1
Offside Direction indicators not working |1.5.1c|1
Headlamp dipped beam affected by the operation of another lamp |1.2.2c|1
Brake pedal mounting cracked . |3.1.2c|1
Brake pedal is inoperative |3.1.3c|1
Offside Footrest insecure |6.2.1a|1
Nearside Footrest insecure |6.2.1a|1
Rear suspension bearing has excessive free play |2.4.A2a|i||1
Floor brake test The less effective brake control does not achieve an efficiency of 25%. |3.3.C1b|1
Horn not loud enough to be heard by another road user |1.7.3a|1
Lower Rear reflector on motorcycle missing |1.4.1|1
Front Brake lever has inadequate reserve travel |3.1.3b|1
Offside Handlebar handgrip not secure to handlebars. |2.1.1c|1
Rear Brake disc|s| cracked |3.2.A1g|1
Front Brake component damaged and seriously reduced in strength |3.2.A1|1
Offside Steering lock stop ineffective |2.1.3|1
Rear Rear position lamp does not illuminate immediately when it is switched on |1.1.3a|1
Nearside Headlamp aim beam image kick up to the offside |1.6|1
Offside Headlamp aim beam image kick up to the offside |1.6|1
Centre Riders seat insecure |6.2.1a|1
Rear Valve stem seriously damaged (5.2.3 (j))1
Rear Wheel bearing has excessive play (5.1.3 (a) (i))1
Front Steering headbearing excessively stiff or notchy |2.2.2 |f| |i||1
Stop lamp does not illuminate immediately a brake applies Control one |1.3.1a|1
Offside Rear Direction indicator insecure |1.5.3b|1
Fuel system component insecure |7.2.1b|1
Rear Stop lamp remains on when the brake is released |1.3.1e|1
Offside Front Direction indicator incorrect colour |1.5.1b|1
Brake pedal insecure |3.1.2a|1
Brake caliper|s| insecure |3.2.A1j|1

We get to these numbers by trawling through over 1 billion MOT test results since 2004 and crunched the numbers. We remove anything to do with Tyres, as they are model independent and group together common non-model specific issues. We are trying to get to a picture of what models have what issues.

Please note: We take the data from the DVSA. This data is raw and can contain typos and spelling mistakes that garages may have entered while recording a MOT result. Specifically miss-match on names of models and makes. We are constantly cleaning the data so bear with the odd issue.

Got suggestions? We’re improving this section all the time. If you have any suggestions, please let us know.

Find us on Facebook

© KnowYourCar™ 2019. All rights reserved
Except where otherwise noted, content on our MOT statistics pages are licensed under a Creative Commons Attribution 4.0 International license.
You are free to redistribute the material in any medium or format as long as credit is given to KnowYourCar

WARNING: We have placed hidden watermarks in our data. We will take action against our data being used outside of these terms.

MOT Data licensed under the Open Government Licence v3.0

By using our site you are agreeing to our terms and conditions
Terms & Conditions  Privacy Policy