| Most common failures | No# failures |
|---|
| Registration plate lamp issues | 11 |
| Windscreen wiper does not clear the windscreen effectively | 7 |
| Anti-lock braking system warning lamp indicates an ABS fault | 2 |
| Windscreen has damage | 2 |
| Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt |6.1.7 |g| |ii|| | 2 |
| Parking brake: efficiency below requirements |3.7.B.7| | 2 |
| Parking brake lever has no reserve travel |3.1.6b| | 2 |
| Brake pipe excessively corroded | 2 |
| Nearside Front Position lamp not working (4.2.1 (a) (ii)) | 2 |
| Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone `A` |8.3.1e| | 1 |
| Offside Side repeater incorrect colour |1.4.A.2f| | 1 |
| Nearside Front Upper Suspension arm has excessive play in a pin/bush |2.4.G.2| | 1 |
| Rear Anti-roll bar linkage has excessive play in a pin/bush |2.4.G.2| | 1 |
| Rear Anti-roll bar rubber mounting deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Horn not working |1.6.2a| | 1 |
| Rear Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Hazard warning lamps inoperative |1.4.B.1b| | 1 |
| Offside Stop lamp not working |1.2.1b| | 1 |
| Nearside Stop lamp not working |1.2.1b| | 1 |
| Nearside Headlamp not working on dipped beam |1.7.5a| | 1 |
| Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
| Nearside Front position lamp|s| not working |1.1.A.3b| | 1 |
| Nearside Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
| Offside Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
| Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
| Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
| Rear brake disc in such a condition that it is seriously weakened | 1 |
| Rear brake disc contaminated by oil |3.5.1h| | 1 |
| Nearside Front Suspension arm rubber bush bonding deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Offside Front Suspension arm rubber bush bonding deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Front Anti-roll bar has excessive play in a pin/bush D bushes |2.4.G.2| | 1 |
| Service brake: efficiency below requirements |3.7.B.7| | 1 |
| Brakes imbalanced across an axle | 1 |
| Rear rear brake excessively fluctuating |3.7.B.3| | 1 |
| rear parking |secondary| brakes imbalanced | 1 |
| rear brake recording little or no effort |3.7.B.5a| | 1 |
| Headlamp aim out of alignment | 1 |
| Nearside Rear fog lamp emits a light other than red |1.3.2e| | 1 |
| Rear parking brake recording little or no effort | 1 |
| Oil leaking excessively from engine |8.4.1 |a| |i|| | 1 |
| Front Anti-roll bar pin or bush excessively worn |5.3.4 |a| |i|| | 1 |
| Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill |5.3.6 |a| |i|| | 1 |
| Offside Rear Service brake excessively fluctuating |1.2.1 |e|| | 1 |
| Nearside Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt |6.1.7 |g| |ii|| | 1 |
| Nearside Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt |6.1.7 |g| |ii|| | 1 |
| Offside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
| Nearside Rear Body has a sharp edge caused by damage |6.1.C.1| | 1 |
| Offside Rear Body has a sharp edge caused by damage |6.1.C.1| | 1 |
| Nearside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
| Offside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
| Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
| Centre Exhaust system not adequately supported |7.1.1| | 1 |
| Nearside Front Wheel nut|s| missing |4.2.A.1e| | 1 |
| Offside Front Wheel nut|s| missing |4.2.A.1e| | 1 |
| Nearside Rear Wheel nut|s| missing |4.2.A.1e| | 1 |
| Offside Rear Wheel nut|s| missing |4.2.A.1e| | 1 |
| Nearside Front Anti-roll bar linkage ball joint excessively worn |5.3.4 |a| |i|| | 1 |
| Offside Front Anti-roll bar linkage missing |5.3.3 |a| |ii|| | 1 |
| Nearside Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength outer sill |5.3.6 |a| |i|| | 1 |
| Offside Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength outer sill |5.3.6 |a| |i|| | 1 |
| Front Service brake excessively fluctuating due to brake discs |1.2.1 |e|| | 1 |
| Windscreen washer not working | 1 |
| Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
| Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
| Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
| Offside Prop shaft joint constant velocity boot no longer prevents the ingress of dirt inner cv boot split (6.1.7 (g) (ii)) | 1 |
| Exhaust has a major leak of exhaust gases middle /rear exhaust as hole in system (6.1.2 (a)) | 1 |
| Nearside Stop lamp|s| not working |4.3.1 |a| |ii|| | 1 |
| Central Stop lamp|s| not working |4.3.1 |a| |ii|| | 1 |
| Offside Rear Stop lamp not working |1.2.1b| | 1 |