| Most common failures | No# failures |
|---|
| Brake pipe excessively corroded | 5 |
| Headlamp aim out of alignment | 4 |
| Offside Front Headlamp aim beam image obviously incorrect |1.8.A.1b| | 2 |
| Nearside Front position lamp|s| not working |1.1.A.3b| | 2 |
| Brake hose excessively deteriorated | 2 |
| Offside Front position lamp|s| not working |1.1.A.3b| | 2 |
| Nearside Front Headlamp aim beam image obviously incorrect |1.8.A.1b| | 2 |
| Exhaust has a major leak of exhaust gases |7.1.2| | 2 |
| Battery insecure |1.9.1| | 2 |
| Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 2 |
| Brakes imbalanced across an axle | 2 |
| Nearside Front Steering component mounting prescribed area is excessively corroded |2.2.C.1h| | 1 |
| Nearside Front Steering component mounting prescribed area is excessively corroded inner chassis where steering box mounts to corroded |2.2.C.1h| | 1 |
| Nearside Front Ball joint has excessive play steering drop arm ball joint excessive play. |2.2.B.1f| | 1 |
| Offside Front Lower Ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt bottom ball joint boot split |2.2.C.1c| | 1 |
| Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings inner rear panel both sides of where the chassis mounts to it corroded |6.1.B.2| | 1 |
| Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings chassis / floor pan to body mounting in the under side of n/s/f wheel arch corroded. |6.1.B.2| | 1 |
| Offside Rear Suspension spring mounting prescribed area is excessively corroded inner wheel arch is corroded |2.4.A.3| | 1 |
| Nearside Rear Suspension spring mounting prescribed area is excessively corroded outer sill corroded |2.4.A.3| | 1 |
| Offside Rear Inner Suspension spring mounting prescribed area is excessively corroded sill |2.4.A.3| | 1 |
| Offside Rear Suspension spring mounting prescribed area is excessively corroded inner sill |2.4.A.3| | 1 |
| Rear brake binding | 1 |
| Rear brake application uneven | 1 |
| Rear fog lamp not working |1.3.2b| | 1 |
| Offside Rear fog lamp missing |1.3.2a| | 1 |
| Front brake disc cracked |3.5.1h| | 1 |
| Emissions not tested |7.0| | 1 |
| Offside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
| Front Windscreen wiper not operating automatically when switched on |8.2.1b| | 1 |
| Fuel cap/sealing device mounting flange/sealing method defective unable to check the fuel cap seal |7.2.4c| | 1 |
| Seat belt locking mechanism does not secure or release unable to check all seat belts on 1st row of seats in the rear due to seats being loaded with wheels |5.2.5a| | 1 |
| Seat belt affected by an insecure seat fixing side ways fitted seats in rear of van are all insecure. |5.2.1b| | 1 |
| Rear Exhaust has a part missing |7.1.1a| | 1 |
| Emissions not tested |7.3.A.1| | 1 |
| Nearside Front Body has a projection caused by damage |6.1.C.1| | 1 |
| Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings Sill |6.1.B.2| | 1 |
| Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings Sill |6.1.B.2| | 1 |
| Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Detachable tow ball assembly inappropriately repaired |6.6.7| | 1 |
| Windscreen wiper does not clear the windscreen effectively | 1 |
| Hazard warning tell tale not working correctly |1.4.B.1e| | 1 |
| Nearside Headlamp not working on main beam |1.7.5a| | 1 |
| Offside Headlamp not working on main beam |1.7.5a| | 1 |
| Offside Rear fog lamp insecure |1.3.2a| | 1 |
| Nearside rear brake recording little or no effort |3.7.B.5a| | 1 |
| Offside Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 1 |
| Nearside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 1 |
| Registration plate lamp issues | 1 |
| Nearside Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
| Parking brake lever has no reserve travel |3.1.6b| | 1 |
| Rear parking brake recording little or no effort | 1 |
| Anti-lock braking system warning lamp does not illuminate |3.4.1b| | 1 |