Most common failures | No# failures |
---|
Registration plate lamp issues | 3 |
Parking brake: efficiency below requirements |3.7.B.7| | 3 |
Windscreen wiper does not clear the windscreen effectively | 2 |
Brake pipe inadequately clipped both rear axle |3.6.B.1| | 1 |
Offside Parking brake inoperative on one side (1.4.1 (a)) | 1 |
Central Prop shaft flexible coupling excessively deteriorated to excess. (6.1.7 (d) (i)) | 1 |
Parking brake efficiency below requirements (1.4.2 (a) (i)) | 1 |
Rear parking brake recording little or no effort | 1 |
Rear Exhaust system not adequately supported section missing |7.1.1| | 1 |
Offside Rear Position lamp not working side light. |4.2.1 |a|| | 1 |
Nearside Stop lamp|s| not working |4.3.1 |a| |ii|| | 1 |
Offside Rear fog lamp not working |4.5.1 |a| |ii|| | 1 |
Offside Parking brake inoperative on one side |1.4.1 |a|| | 1 |
Parking brake efficiency below requirements |1.4.2 |a| |i|| | 1 |
Seat belt anchorage prescribed area strength or continuity significantly reduced offside front door step (7.1.1 (a) (i)) | 1 |
Seat belt anchorage prescribed area strength or continuity significantly reduced nearside front door step (7.1.1 (a) (i)) | 1 |
Seat belt anchorage prescribed area strength or continuity significantly reduced offside rear inner sill (7.1.1 (a) (i)) | 1 |
Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i)) | 1 |
Seat belt anchorage prescribed area strength or continuity significantly reduced Offside sill (7.1.1 (a) (i)) | 1 |
Seat belt anchorage prescribed area strength or continuity significantly reduced Offside floor to sill (7.1.1 (a) (i)) | 1 |
Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
Exhaust emits an excessive level of metered smoke for a turbo charged engine |7.4.B.3b| | 1 |
Rear Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Offside rear brake recording little or no effort |3.7.B.5a| | 1 |
Offside Front Position lamp not working |4.2.1 |a| |ii|| | 1 |
Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced Floor pan split |7.1.1 |a| |i|| | 1 |
Headlamp aim out of alignment | 1 |
Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner sills x3 (6.2.2 (d) (i)) | 1 |
Nearside Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
Headlamp aim projected beam image is obviously incorrect both front headlamps dipping up to the opposite direction (4.1.2 (c)) | 1 |
Offside Rear Rear fog lamp missing (4.5.1 (a) (ii)) | 1 |
Offside Front position lamp|s| not working |1.1.A.3b| | 1 |