| Most common failures | No# failures |
|---|
| Headlamp aim out of alignment | 4 |
| Steering box has excessive free play detected at the steering wheel to the extent that safe steering is affected |steering box fitted| |2.3 |a| |ii|| | 1 |
| Front Drag link end ball joint has excessive play |2.1.3 |b| |i|| | 1 |
| Offside Front Position lamp not working |4.2.1 |a|| | 1 |
| Offside Rear Position lamp not working |4.2.1 |a|| | 1 |
| Service brake: efficiency below requirements |3.7.B.7| | 1 |
| Horn not working |1.6.2a| | 1 |
| Suspension arm has excessive play in a pin/bush rear trayling arm bushes |2.4.G.2| | 1 |
| Rear Suspension component mounting prescribed area is excessively corroded body to moutings |2.4.A.3| | 1 |
| Offside Front Suspension component mounting prescribed area is excessively corroded floor to body |2.4.A.3| | 1 |
| Offside Rear Brake pipe twisted |found during steering lock to lock check| |2.2.D.2b| | 1 |
| Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) | 1 |
| Nearside Rear Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
| Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
| Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
| Windscreen washer not working | 1 |
| Parking (secondary brake) on a single line braking system has inadequate effort at a wheel (1.3.1 (a) (i)) | 1 |
| Brake lever has insufficient reserve travel (1.1.2 (a)) | 1 |
| Rear Exhaust emissions likely to be affected by an exhaust leak (8.2.2.1 (b)) | 1 |
| Offside Front Drag link end ball joint has excessive play both link ends (2.1.3 (b) (i)) | 1 |
| Offside Front Steering component mounting prescribed area is excessively corroded chassis leg (2.1.2 (e) (i)) | 1 |
| Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b)) | 1 |
| Service brake efficiency below requirements (1.2.2 (a) (i)) | 1 |
| Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Nearside Front Suspension component mounting prescribed area is excessively corroded chassis |2.4.A.3| | 1 |
| Offside Headlamp not working on main beam |1.7.5a| | 1 |