| Most common failures | No# failures |
|---|
| Parking brake: efficiency below requirements |3.7.B.7| | 2 |
| Offside Front Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Inner wheel arch (6.2.2 (d) (i)) | 2 |
| Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength anti-roll bar mount |5.3.6 |a| |i|| | 1 |
| Offside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength |5.3.6 |a| |i|| | 1 |
| Nearside Front Lower Suspension arm ball joint excessively worn |5.3.4 |a| |i|| | 1 |
| Rear Prop shaft bearing excessively worn |6.1.7 |b| |i|| | 1 |
| Nearside Front Bumper insecure |6.1.4 |a| |i|| | 1 |
| Offside Rear fog lamp not working |1.3.2b| | 1 |
| Registration plate issues | 1 |
| Nearside Brake cable has wires broken and is significantly weakened |3.5.1b| | 1 |
| Offside Brake cable has wires broken and is significantly weakened |3.5.1b| | 1 |
| Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Nearside Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
| Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i)) | 1 |
| Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i)) | 1 |
| Horn not working |1.6.2a| | 1 |
| Nearside Stop lamp not working |1.2.1b| | 1 |
| Offside Rear Suspension component mounting prescribed area is excessively corroded anti roll bar linkage mount |2.4.A.3| | 1 |
| Offside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner wing and chassis rail |6.1.1 |c| |i|| | 1 |
| Nearside Rear Position lamp not working Side light (4.2.1 (a) (ii)) | 1 |
| Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
| Nearside Front Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Inner wheel arch (6.2.2 (d) (i)) | 1 |
| Headlamp not working on dipped beam NSF and OSF (4.1.1 (a) (ii)) | 1 |
| Offside Front Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Seel (6.1.1 (c) (i)) | 1 |
| Horn not working (7.7 (a)) | 1 |
| Drivers door cannot be opened from outside the vehicle (6.2.3 (a)) | 1 |
| Nearside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Offside Rear Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Offside Front Upper Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
| Nearside Front wheel bearing rough when rotated |2.5.A.2| | 1 |
| Offside Front Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
| Nearside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Offside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Exhaust emits an excessive level of metered smoke for a turbo charged engine |7.4.B.3b| | 1 |