| Most common failures | No# failures |
|---|
| Brake pipe excessively corroded | 9 |
| Headlamp aim out of alignment | 6 |
| Windscreen wiper does not clear the windscreen effectively | 4 |
| Brakes imbalanced across an axle | 3 |
| Exhaust emissions exceed level of metered smoke for a non-turbo charged engine (8.2.2.2 (b)) | 3 |
| Offside Rear fog lamp not working |1.3.2b| | 3 |
| Parking brake efficiency below requirements (1.4.2 (a) (i)) | 2 |
| Supplementary restraint system warning lamp indicates a fault (7.1.6 (a)) | 2 |
| Offside Front Lower Suspension component mounting prescribed area excessively corroded significantly reducing structural strength arm front mounting (5.3.6 (a) (i)) | 2 |
| Offside Rear Rear fog lamp not working |1.3.2b| | 2 |
| Offside front brake binding |3.7.B.1| | 2 |
| Nearside front brake binding |3.7.B.1| | 2 |
| Brake hose excessively deteriorated | 2 |
| Registration plate issues | 2 |
| Registration plate lamp issues | 2 |
| Nearside Stop lamp not working |1.2.1b| | 2 |
| Nearside Rear position lamp|s| not working |1.1.A.3b| | 2 |
| Offside Hazard warning lamps not flashing in phase, with ignition off |1.4.B.1f| | 1 |
| Nearside Headlamp aim aimed so that it dazzles other road users |1.8.A.1a| | 1 |
| Offside Front Anti-roll bar has excessive play in a pin/bush |2.4.G.2| | 1 |
| Offside Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
| Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength |5.3.6 |a| |i|| | 1 |
| Rear Exhaust has a major leak of exhaust gases (6.1.2 (a)) | 1 |
| Offside Rear Suspension component mounting prescribed area is excessively corroded inner sill |2.4.A.3| | 1 |
| Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
| Offside Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i)) | 1 |
| Offside Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i)) | 1 |
| Offside Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch (5.3.6 (a) (i)) | 1 |
| Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch (5.3.6 (a) (i)) | 1 |
| Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i)) | 1 |
| Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill after wheel arch (5.3.6 (a) (i)) | 1 |
| Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch shocker top (5.3.6 (a) (i)) | 1 |
| Stop lamp(s) all not working (4.3.1 (a) (iii)) | 1 |
| Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength X member (5.3.6 (a) (i)) | 1 |
| Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength X member (5.3.6 (a) (i)) | 1 |
| Nearside Rear Shock absorber has an excessively worn bush (2.7.4) | 1 |
| Offside Rear Shock absorber has an excessively worn bush (2.7.4) | 1 |
| Nearside Rear Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Front Prop shaft flexible coupling excessively deteriorated (6.1.7 (d) (i)) | 1 |
| Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength spring rear mounting (5.3.6 (a) (i)) | 1 |
| Brake pedal anti-slip provision missing (3.3.A.1b) | 1 |
| Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength spring front mounting inner sill (5.3.6 (a) (i)) | 1 |
| Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength spring front mounting outer sill (5.3.6 (a) (i)) | 1 |
| Offside Front coil spring incomplete (2.4.C.1a) | 1 |
| Front Exhaust has a major leak of exhaust gases (7.1.2) | 1 |
| Exhaust emits an excessive level of metered smoke for a non-turbo charged engine (7.4.B.3b) | 1 |
| Nearside Rear Stop lamp not working (1.2.1b) | 1 |
| Parking brake: efficiency below requirements |3.7.B.7| | 1 |
| Nearside Rear Anti-roll bar rubber mounting bonding deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Windscreen has damage | 1 |
| Offside Front Lower Tie bar/rod has excessive play in a ball joint |2.4.G.2| | 1 |
| Offside Front Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
| Nearside Battery insecure |1.9.1| | 1 |
| Offside Battery insecure |1.9.1| | 1 |
| Nearside Side repeater not working |4.4.1 |a| |ii|| | 1 |
| Offside Front Lower Suspension component ball joint dust cover no longer prevents the ingress of dirt |5.3.4 |b| |ii|| | 1 |
| Power steering pipe/hose excessively corroded at steeringbox |2.1.5 |g| |i|| | 1 |
| Offside Obligatory mirror insecure |3.3 |b| |ii|| | 1 |
| Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Rear Outline marker lamp not working (4.2.1 (a) (ii)) | 1 |
| Offside Rear Brake hose kinked |3.6.B.4b| | 1 |
| Offside Front front brake binding |3.7.B.1| | 1 |
| Nearside Front Lower Front suspension ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
| Offside Front Lower Front suspension ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
| Nearside Front Upper Front suspension ball joint dust cover missing |2.4.G.2| | 1 |
| Offside Front Upper Front suspension ball joint dust cover missing |2.4.G.2| | 1 |
| Nearside Front Service brake excessively binding (1.2.1 (f)) | 1 |
| Exhaust has a major leak of exhaust gases Manifold (6.1.2 (a)) | 1 |
| Nearside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Wheel arch within 30cm of strut mounting (6.2.2 (d) (i)) | 1 |
| Central Exhaust has a major leak of exhaust gases snapped off (6.1.2 (a)) | 1 |
| Rear Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Emissions not tested |7.4.B.1| | 1 |
| Nearside Front Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced + outer sill corroded (6.1.1 (c) (i)) | 1 |
| Offside Front Inner Vehicle structure strengthening plate or fastening insecure sill welding not don properly (upper plate not welded to body) (6.1.1 (b) (i)) | 1 |
| Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Front Direction indicator not working |1.4.A.2c| | 1 |
| Horn not working |1.6.2a| | 1 |
| Offside front brake grabbing severely |3.7.A.2b| | 1 |
| Nearside Side repeater missing |1.4.A.2b| | 1 |
| Offside Side repeater missing |1.4.A.2b| | 1 |
| Fuel pipe leaking |7.2.3| | 1 |
| Nearside Steering rack gaiter split |2.2.D.2d| | 1 |
| Nearside Rear Stop lamp not working |1.2.1b| | 1 |
| Offside Stop lamp not working |1.2.1b| | 1 |
| Offside Hazard warning lamps not flashing in phase, with ignition on |1.4.B.1f| | 1 |
| Fuel system component leaking Around fuel pump |7.2.3| | 1 |
| Offside Front brake disc excessively pitted |3.5.1h| | 1 |
| Service brake: efficiency below requirements |3.7.B.7| | 1 |