Most common failures | No# failures |
---|
Headlamp aim out of alignment | 4 |
Parking brake: efficiency below requirements |3.7.B.7| | 3 |
Rear parking brake recording little or no effort | 2 |
Rear fog lamp not working |1.3.2b| | 2 |
Registration plate lamp issues | 2 |
Parking brake lever has no reserve travel |3.1.6b| | 2 |
Rear brake binding | 2 |
Offside Rear Brake hose leaking |3.6.A.1| | 1 |
Nearside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
Rear fog lamp tell tale not working |1.3.1b| | 1 |
Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
Offside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
Nearside Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 1 |
Offside Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 1 |
Brake pipe inadequately clipped |3.6.B.1| | 1 |
Brake pipe inadequately supported |3.6.B.1| | 1 |
Nearside Seat belt anchorage prescribed area is inadequately repaired |5.2.6| | 1 |
Offside Front Upper Suspension component mounting prescribed area excessively corroded significantly reducing structural strength suspension upper turret assembly / upright mounting point excessively corroded (5.3.6 (a) (i)) | 1 |
Offside Front Upper Suspension arm ball joint excessively worn Upper wishbone outer. (5.3.4 (a) (i)) | 1 |
Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b)) | 1 |
Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i)) | 1 |
Brake lever has insufficient reserve travel (1.1.2 (a)) | 1 |
Offside Front All direction indicators not working (4.4.1 (a) (ii)) | 1 |
Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b)) | 1 |
Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturers specified limits (8.2.1.2 (a)) | 1 |
Nearside Front Service brake excessively binding (1.2.1 (f)) | 1 |
Offside Front Service brake excessively fluctuating (1.2.1 (e)) | 1 |
Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch at top mounting (5.3.6 (a) (i)) | 1 |
Parking brake efficiency below requirements (1.4.2 (a) (i)) | 1 |