Most common failures | No# failures |
---|
Registration plate lamp issues | 6 |
Rear parking brake recording little or no effort | 4 |
Nearside Stop lamp not working |1.2.1b| | 4 |
Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 4 |
Horn not working |1.6.2a| | 2 |
Brake pipe excessively corroded | 2 |
Rear fog lamp switch faulty |1.3.1a| | 2 |
Brakes imbalanced across an axle | 2 |
Nearside Headlamp not working on dipped beam |1.7.5a| | 2 |
Nearside Steering rack gaiter split |2.2.D.2d| | 2 |
Offside Rear fog lamp not working |1.3.2b| | 2 |
Offside Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Offside Rear Braking system leaking |3.6.A.1| | 2 |
Headlamp aim out of alignment | 2 |
Parking brake: efficiency below requirements |3.7.B.7| | 2 |
Exhaust system not adequately supported |7.1.1| | 2 |
Exhaust emissions hydrocarbon content excessive (8.2.1.2 (b)) | 1 |
Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b)) | 1 |
Offside Rear Hydraulic brake cylinder leaking and braking performance affected (1.1.16 (b) (ii)) | 1 |
Battery insecure and likely to fall from carrier (4.13 (a) (ii)) | 1 |
Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Chassis leg (6.1.1 (c) (i)) | 1 |
Offside Front Vehicle structure inadequately repaired such that structural rigidity is significantly reduced Inner chassis leg (6.1.1 (d) (i)) | 1 |
Nearside Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Inner sill / step (6.1.1 (c) (i)) | 1 |
Windscreen has damage | 1 |
Nearside Windscreen wiper blade deteriorated |8.2.2| | 1 |
Offside Windscreen wiper blade deteriorated |8.2.2| | 1 |
Offside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Rear Shock absorber has an excessively worn bush |2.7.4| | 1 |
Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
Spare wheel insecure |6.4.2| | 1 |
Nearside Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear position lamp|s| adversely affected by the operation of another lamp |1.1.A.3f| | 1 |
Offside Steering rack gaiter split |2.2.D.2d| | 1 |
Nearside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Front Upper Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Offside Rear brake drum contaminated by brake fluid |3.5.1h| | 1 |
Rear brake application uneven | 1 |
Offside Stop lamp not working |1.2.1b| | 1 |
Nearside Front Seat belt anchorage prescribed area is excessively corroded sill |5.2.6| | 1 |
Offside Rear Suspension spring mounting prescribed area is excessively corroded sill |2.4.A.3| | 1 |
Rear Brake pipe leaking |3.6.A.1| | 1 |
Nearside rear brake recording little or no effort |3.7.B.5a| | 1 |
Offside rear brake recording little or no effort |3.7.B.5a| | 1 |
Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Service brake: efficiency below requirements |3.7.B.7| | 1 |
Offside Rear Position lamp not working (4.2.1 (a) (ii)) | 1 |
Offside Headlamp insecure |1.7.3| | 1 |
Front Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Offside Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
Windscreen wiper does not clear the windscreen effectively | 1 |
Nearside Rear position lamp|s| adversely affected by the operation of another lamp |1.1.A.3f| | 1 |
Offside Steering rack gaiter split and nearside |2.2.D.2d| | 1 |
Offside Seat belt anchorage prescribed area is excessively corroded inner step |5.2.6| | 1 |
Offside Rear Suspension spring mounting prescribed area is excessively corroded outer sill |2.4.A.3| | 1 |
Nearside Rear Suspension spring mounting prescribed area is excessively corroded inner and outer sill |2.4.A.3| | 1 |
Nearside Vehicle structure has excessive corrosion which adversely affects braking or steering centeral sill |6.1.A.1| | 1 |
Offside Suspension spring mounting prescribed area is excessively corroded and nearside rear x member |2.4.A.3| | 1 |
Nearside Rear Lower Shock absorber has an excessively worn bush |2.7.4| | 1 |
Offside Rear Lower Shock absorber has an excessively worn bush |2.7.4| | 1 |
Nearside Headlamp insecure |1.7.3| | 1 |
Brake pedal anti-slip provision loose |3.3.A.1b| | 1 |
Vehicle Identification Number not permanently displayed |6.3.5.a| | 1 |
Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Rear Air suspension bellows leaking |2.4.D.2| | 1 |
Nearside Rear Leaf spring deteriorated and seriously weakened |2.4.B.1a| | 1 |
Offside Rear Leaf spring deteriorated and seriously weakened |2.4.B.1a| | 1 |
Rear Suspension has inadequate clearance with the bump stop |2.4.A.1a| | 1 |
Nearside Rear Suspension weakened allowing body or other component to foul a road wheel or would do so if laden |2.4.A.1b| | 1 |
Offside Rear Suspension weakened allowing body or other component to foul a road wheel or would do so if laden |2.4.A.1b| | 1 |
Nearside Rear Suspension has inadequate clearance with the bump stop |2.4.A.1a| | 1 |
Offside Rear Suspension has inadequate clearance with the bump stop |2.4.A.1a| | 1 |
Offside Rear Body has a sharp edge caused by damage |6.1.C.1| | 1 |
Registration plate issues | 1 |
Brake hose excessively deteriorated | 1 |
Nearside Front Direction indicators flashing more than 120 times a minute |1.4.A.2g| | 1 |
Offside Front Direction indicators flashing more than 120 times a minute |1.4.A.2g| | 1 |
Nearside Rear Direction indicators incorrect colour |1.4.A.2f| | 1 |
Offside Rear Stop lamp not working |1.2.1b| | 1 |
Nearside Front Anti-roll bar rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Nearside Front brake caliper securing device missing |3.5.1j| | 1 |
Nearside Front front brake binding |3.7.B.1| | 1 |
Front Electrical wiring insecure |1.9.2a| | 1 |
Electrical wiring inadequately supported |1.9.2a| | 1 |
Nearside Front Axle king pin has excessive play in pin and/or bush adversely affecting the steering |2.5.A.3a| | 1 |
Offside Front Axle king pin has excessive play in pin and/or bush adversely affecting the steering |2.5.A.3a| | 1 |
Emissions not tested |7.3.A.1| | 1 |
Service brake: efficiency below requirements |3.7.C.1a| | 1 |
Front brake application uneven | 1 |