| Most common failures | No# failures |
|---|
| Registration plate lamp issues | 7 |
| Rear fog lamp not working (4.5.1 (a) (ii)) | 4 |
| Windscreen wiper does not clear the windscreen effectively | 4 |
| Offside Front Service brake excessively binding (1.2.1 (f)) | 2 |
| Brakes imbalanced across an axle | 2 |
| Horn not working |1.6.2a| | 2 |
| Offside Front position lamp|s| not working |1.1.A.3b| | 2 |
| Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength x member (5.3.6 (a) (i)) | 1 |
| Rear Exhaust has a major leak of exhaust gases (6.1.2 (a)) | 1 |
| Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength chassis (5.3.6 (a) (i)) | 1 |
| Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength inner wing (5.3.6 (a) (i)) | 1 |
| Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength inner wing (5.3.6 (a) (i)) | 1 |
| Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength outrigger (5.3.6 (a) (i)) | 1 |
| Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength outrigger (5.3.6 (a) (i)) | 1 |
| Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced inner arch (various places) (7.1.1 (a) (i)) | 1 |
| Nearside Rear Seat belt anchorage prescribed area is inadequately repaired inner arch (7.1.1 (a) (i)) | 1 |
| Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch (5.3.6 (a) (i)) | 1 |
| Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill (7.1.1 (a) (i)) | 1 |
| Offside Rear Service brake excessively binding (1.2.1 (f)) | 1 |
| Nearside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Offside Front Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i)) | 1 |
| Power steering component leaking (2.1.5 (a)) | 1 |
| Nearside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i)) | 1 |
| Suspension component mounting prescribed area excessively corroded significantly reducing structural strength near and off side front chassis [under radiator] (5.3.6 (a) (i)) | 1 |
| Nearside Body panel corroded and likely to cause injury sill (6.2.1 (a) (i)) | 1 |
| Offside Rear Suspension component mounting prescribed area is inadequately repaired chassis by spring mounting (5.3.6 (a) (i)) | 1 |
| Offside Front Upper Suspension component mounting prescribed area excessively corroded significantly reducing structural strength shock mounting (5.3.6 (a) (i)) | 1 |
| Fuel cap/sealing device ineffective does not fasten securely by positive means (6.1.3 (b) (i)) | 1 |
| Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt upper and lower (5.3.4 (b) (ii)) | 1 |
| Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength cross member (5.3.6 (a) (i)) | 1 |
| Offside Headlamp light intensity severely reduced bad connection in the plug on the bulb (4.1.4 (a)) | 1 |
| Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
| Rear fog lamp likely to become detached (4.5.1 (c) (ii)) | 1 |
| Nearside Front Lower Suspension component ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
| Offside Front Lower Suspension component ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
| Offside Rear Upper Coil spring mounting damaged and seriously weakened (5.3.1 (b) (i)) | 1 |
| Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill area (5.3.6 (a) (i)) | 1 |
| Offside Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill area (5.3.6 (a) (i)) | 1 |
| Offside Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
| Offside Parking brake inoperative on one side (1.4.1 (a)) | 1 |
| Nearside Rear Body panel damaged and likely to cause injury Wheel arch (6.2.1 (a) (i)) | 1 |
| Exhaust emits excessive smoke or vapour likely to obscure the vision of other road users (8.2.2.2 (c)) | 1 |
| Parking brake efficiency below requirements (1.4.2 (a) (i)) | 1 |
| Headlamp incorrect colour |1.7.5b| | 1 |
| Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
| Rear fog lamp tell tale missing |1.3.1b| | 1 |
| Exhaust emits an excessive level of metered smoke for a turbo charged engine |7.4.B.3b| | 1 |
| Horn not working (7.7 (a)) | 1 |
| Fuel cap/sealing device missing |7.2.4a| | 1 |
| Nearside Front Position lamp not working |4.2.1 |a|| | 1 |
| Rear fog lamp tell-tale not working |4.9.1 |a| |ii|| | 1 |
| Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill |5.3.6 |a| |i|| | 1 |
| Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill |5.3.6 |a| |i|| | 1 |
| Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill |5.3.6 |a| |i|| | 1 |
| Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill end cap / inner wheel arch |5.3.6 |a| |i|| | 1 |
| Nearside Front Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
| Nearside Rear Stop lamp not working |1.2.1b| | 1 |
| Rear fog lamp tell tale not working |1.3.1b| | 1 |
| Windscreen wiper blade insecure | 1 |
| Offside Rear Rear fog lamp missing |1.3.2a| | 1 |
| Registration plate issues | 1 |
| Headlamp switch insecure |1.7.1| | 1 |
| Front Side repeater missing |1.4.A.2b| | 1 |
| Front Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
| Nearside Front Track rod end ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
| Offside Front Track rod end ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
| Nearside Front Lower Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
| Offside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength o/s + n/s inner sills (5.3.6 (a) (i)) | 1 |
| Rear Shock absorbers has an excessively worn bush o/s + n/s (5.3.2 (c)) | 1 |
| Offside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b)) | 1 |
| Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner arch/rear sill (5.3.6 (a) (i)) | 1 |
| Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner arch/rear sill (5.3.6 (a) (i)) | 1 |
| Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Outer Sill (6.1.1 (c) (i)) | 1 |
| Nearside Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Inner Sill (6.1.1 (c) (i)) | 1 |
| Nearside Rear Vehicle structure excessively corroded within 30cm of towbar mounting (6.1.6 (i) (i)) | 1 |
| Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Inner sill (6.1.1 (c) (i)) | 1 |
| Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner Sill (5.3.6 (a) (i)) | 1 |