| Most common failures | No# failures |
|---|
| Rear fog lamp not working (4.5.1 (a) (ii)) | 4 |
| Service brake efficiency below requirements (1.2.2 (a) (i)) | 3 |
| Offside Front Service brake excessively binding (1.2.1 (f)) | 2 |
| Registration plate issues | 2 |
| Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i)) | 2 |
| Registration plate lamp issues | 2 |
| Brake pipe excessively corroded | 2 |
| Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 2 |
| Nearside Front position lamp|s| incorrect colour |1.1.A.3e| | 2 |
| Offside Front position lamp|s| incorrect colour |1.1.A.3e| | 2 |
| Anti-lock braking system warning lamp indicates an ABS fault | 2 |
| Supplementary restraint system warning lamp indicates a fault (7.1.6 (a)) | 2 |
| Fuel cap/sealing device ineffective (6.1.3 (b) (i)) | 2 |
| Headlamp aim out of alignment | 2 |
| Offside Rear Rear fog lamp not working (4.5.1 (a) (ii)) | 2 |
| Front brake disc in such a condition that it is seriously weakened | 2 |
| Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i)) | 2 |
| Offside Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
| Offside Front Vehicle structure inadequately repaired such that structural rigidity is significantly reduced chassis leg (6.1.1 (d) (i)) | 1 |
| Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill (6.1.1 (c) (i)) | 1 |
| Central Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced offside inner sill (6.1.1 (c) (i)) | 1 |
| Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill (6.1.1 (c) (i)) | 1 |
| Nearside Front Subframe mounting prescribed area so inadequately repaired that control of the vehicle is likely to be adversely affected x-member (5.3.6 (a) (ii)) | 1 |
| Offside Front Subframe mounting prescribed area so inadequately repaired that control of the vehicle is likely to be adversely affected x-member (5.3.6 (a) (ii)) | 1 |
| Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength x-member (5.3.6 (a) (i)) | 1 |
| Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength x-member (5.3.6 (a) (i)) | 1 |
| Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c)) | 1 |
| Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength rear (5.3.6 (a) (i)) | 1 |
| Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength front (5.3.6 (a) (i)) | 1 |
| Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength front (5.3.6 (a) (i)) | 1 |
| Offside Front Subframe mounting prescribed area is inadequately repaired under wheel arch (5.3.6 (a) (i)) | 1 |
| Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
| Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
| Nearside Front Headlamp not working on main beam (4.1.1 (a) (ii)) | 1 |
| Windscreen wiper does not clear the windscreen effectively | 1 |
| Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill and chassis (5.3.6 (a) (i)) | 1 |
| Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill and chassis (5.3.6 (a) (i)) | 1 |
| Rear Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
| Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
| Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
| Offside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner sill (6.2.2 (d) (i)) | 1 |
| Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting outer sill (6.2.2 (d) (i)) | 1 |
| Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i)) | 1 |
| Exhaust has a major leak of exhaust gases tail box (6.1.2 (a)) | 1 |
| Emissions not tested (8.2.2.2 (e)) | 1 |
| Horn not working |1.6.2a| | 1 |
| Rear fog lamp not working |1.3.2b| | 1 |
| Nearside Front Inner Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings floor and outrigger |6.1.B.2| | 1 |
| Offside Front Inner Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings floor and outrigger |6.1.B.2| | 1 |
| Nearside Rear Inner Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill behind axle |6.1.B.2| | 1 |
| Offside Rear Inner Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill behind axle |6.1.B.2| | 1 |
| Nearside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i)) | 1 |
| Nearside Inner Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i)) | 1 |
| Offside Inner Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i)) | 1 |
| Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced innerwheel arch lower 1/4 (7.1.1 (a) (i)) | 1 |
| Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced wheel arch rear 1/4 (7.1.1 (a) (i)) | 1 |
| Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i)) | 1 |
| Offside Front Direction indicator not working (4.4.1 (a) (ii)) | 1 |
| Towbar attachment insecure (6.1.6 (c) (i)) | 1 |
| Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt Both (5.3.4 (b) (ii)) | 1 |
| Fuel hose leaking (6.1.3 (b) (i)) | 1 |
| Emissions not tested (8.2.1.2 (d)) | 1 |
| Horn not working (7.7 (a)) | 1 |
| Windscreen washer not working | 1 |
| Exhaust has a major leak of exhaust gases BROKEN AWAY (6.1.2 (a)) | 1 |
| Nearside Front Service brake excessively binding (1.2.1 (f)) | 1 |
| Power steering component leaking (2.1.5 (a)) | 1 |
| Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i)) | 1 |
| Offside Front Lower Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced cross member (6.1.1 (c) (i)) | 1 |
| Rear fog lamp missing (4.5.1 (a) (ii)) | 1 |
| Rear fog lamp switch missing (4.5.3 (a)) | 1 |
| Drivers view of the road through the swept area of the windscreen significantly affected by an obstruction items hanging from interior mirror (3.1 (a) (ii)) | 1 |
| Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i)) | 1 |
| Fuel cap/sealing device missing (6.1.3 (b) (i)) | 1 |
| Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
| Road wheel fixing missing all wheels (5.2.1 (a) (i)) | 1 |
| Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i)) | 1 |
| Nearside Rear Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i)) | 1 |
| Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength slam panal (5.3.6 (a) (i)) | 1 |
| Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength slam panal (5.3.6 (a) (i)) | 1 |
| Nearside Rear Vehicle structure excessively corroded within 30cm of towbar mounting (6.1.6 (i) (i)) | 1 |
| Nearside Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b)) | 1 |
| Offside Headlamp has a product on the light source so that the light output is severely reduced (4.1.4 (b)) | 1 |
| Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch (5.3.6 (a) (i)) | 1 |
| Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i)) | 1 |
| Offside Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i)) | 1 |
| Offside Rear Inner Suspension component mounting prescribed area is inadequately repaired sill (5.3.6 (a) (i)) | 1 |
| Offside Rear Anti-roll bar ball joint excessively worn (5.3.4 (a) (i)) | 1 |
| Nearside Rear Anti-roll bar ball joint excessively worn (5.3.4 (a) (i)) | 1 |
| Nearside Rear Seat belt buckle missing (7.1.2 (d)) | 1 |
| Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength lower sill (5.3.6 (a) (i)) | 1 |