Most common failures | No# failures |
---|
Brake pipe excessively corroded | 4 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Nearside Front Direction indicator not working wing (4.4.1 (a) (ii)) | 1 |
Nearside Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
Offside Rear Suspension component mounting prescribed area excessively damaged significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced door apperature (7.1.1 (a) (i)) | 1 |
Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill (7.1.1 (a) (i)) | 1 |
Brakes imbalanced across an axle | 1 |
Offside Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
Nearside Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength |5.3.6 |a| |i|| | 1 |
Windscreen wiper does not clear the windscreen effectively | 1 |
Nearside Front brake disc excessively pitted |3.5.1h| | 1 |
Offside Front brake disc excessively pitted |3.5.1h| | 1 |
Headlamp aim out of alignment | 1 |
Offside Front Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
Position lamp switch missing |1.1.A.1| | 1 |
Indicator switch missing |1.4.A.1| | 1 |
Offside Front Headlamp not working on main beam |1.7.5a| | 1 |
Offside Stop lamp not working |1.2.1b| | 1 |
Registration plate lamp issues | 1 |
Offside Rear fog lamp not working |1.3.2b| | 1 |
Nearside Side repeater missing |1.4.A.2b| | 1 |
Rear Suspension component mounting prescribed area is fractured |2.4.A.3| | 1 |
Offside Front Headlamp insecure |1.7.3| | 1 |
Horn not a continuous or uniform sound |1.6.2e| | 1 |
Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Brake master cylinder/servo mounting prescribed area is excessively corroded |3.6.C.3| | 1 |
Nearside Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Front Anti-roll bar rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Offside Front Anti-roll bar rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Nearside Front Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
Nearside Front Suspension arm locating pin retaining device not properly locked |2.4.G.3b| | 1 |
Nearside Front Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
Offside Front Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
Rear parking brake recording little or no effort | 1 |
Offside rear brake recording little or no effort |3.7.B.5a| | 1 |
Parking brake: efficiency below requirements |3.7.B.7| | 1 |
Nearside Front coil spring incomplete |2.4.C.1a| | 1 |
Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |