Most common failures | No# failures |
---|
Headlamp aim out of alignment | 5 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 3 |
Nearside rear brake recording little or no effort |3.7.B.5a| | 2 |
Offside rear brake recording little or no effort |3.7.B.5a| | 2 |
Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Offside Rear position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Front Headlamp aim beam image kick up to the offside |1.8| | 1 |
Offside Front Headlamp aim beam image kick up to the offside |1.8| | 1 |
Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt |6.1.7 |g| |ii|| | 1 |
Nearside Front Wheel bearing so rough it is likely to overheat or break up (5.1.3 (b) (ii)) | 1 |
Offside Rear Rear fog lamp missing |1.3.2a| | 1 |
Brake load sensing valve linkage seized |3.6.E.3| | 1 |
Nearside Front Outer Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
Nearside Front Front wheel bearing rough when rotated |2.5.A.2| | 1 |
Offside Front Front wheel bearing has excessive play |2.5.A.3c| | 1 |
Nearside Rear wheel bearing has excessive play |2.6.2| | 1 |
Nearside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Service brake: efficiency below requirements |3.7.B.7| | 1 |
Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Front Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
Nearside Front Suspension arm rubber mounting deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Offside Lower Front suspension ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
Offside Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 1 |
Centre Rear Parking brake mechanism/associated mounting prescribed area is excessively corroded |3.1.9| | 1 |
Rear Exhaust system not adequately supported |7.1.1| | 1 |
Nearside Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 1 |
Nearside Front Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
Offside Front Passenger`s seat insecure |6.2.A.1| | 1 |
Offside Front Brake pipe inadequately supported |3.6.B.1| | 1 |
Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Headlamp aim beam image kick up to the offside |1.8| | 1 |
Nearside Headlamp not working on dipped beam |1.7.5a| | 1 |
Offside Rear fog lamp insecure |1.3.2a| | 1 |
Offside Front Direction indicator incorrect colour |1.4.A.2f| | 1 |
Offside Inner Front constant velocity joint is insecure |2.5.C.1b| | 1 |
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |