Most common failures | No# failures |
---|
Brakes imbalanced across an axle | 6 |
Headlamp aim out of alignment | 6 |
Brake hose excessively deteriorated | 6 |
Parking brake: efficiency below requirements |3.7.B.7| | 5 |
Windscreen wiper does not clear the windscreen effectively | 3 |
Nearside Side repeater not working |1.4.A.2c| | 3 |
Rear parking brake recording little or no effort | 3 |
Registration plate lamp issues | 3 |
Nearside Front Direction indicator incomplete |1.5.A1b| | 2 |
Nearside Front constant velocity joint gaiter split |2.5.C.1a| | 2 |
Offside Rear fog lamp not working |1.3.2b| | 2 |
Parking brake lever has no reserve travel |3.1.6b| | 2 |
Nearside rear brake recording little or no effort |3.7.B.5a| | 2 |
Service brake: efficiency below requirements |3.7.B.7| | 2 |
Offside Obligatory mirror seriously deteriorated, affecting the rear view |8.1.2a| | 1 |
Rear fog lamp tell tale not working |1.3.1b| | 1 |
Offside Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
Nearside Front Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
Nearside Front Headlamp insecure |1.7.3| | 1 |
Offside Front Headlamp insecure |1.7.3| | 1 |
Offside Side repeater not working |1.4.A.2c| | 1 |
Brake pipe excessively corroded | 1 |
Rear Brake load sensing valve linkage seized |3.6.E.3| | 1 |
Nearside Inner Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Inner Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Front front brake binding |3.7.B.1| | 1 |
Offside Front front brake binding |3.7.B.1| | 1 |
Offside Rear front brake binding |3.7.B.1| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front position lamp|s| not working |1.1.A.3b| | 1 |
Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
Emissions not tested |7.0| | 1 |
Brake pedal anti-slip provision missing |3.3.A.1b| | 1 |
Position lamp switch faulty |1.1.A.1| | 1 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Rear fog lamp not working |1.3.2b| | 1 |
Offside front brake recording little or no effort |3.7.B.5a| | 1 |
Offside rear brake recording little or no effort |3.7.B.5a| | 1 |
Offside Rear Trailing arm has excessive play in a pin/bearing |2.4.G.2| | 1 |
Brake pedal anti-slip provision incomplete |3.3.A.1b| | 1 |
Offside Front Side repeater not working |1.4.A.2c| | 1 |
Front brake application uneven | 1 |
Offside Headlamp aim beam image kick up to the offside |1.8| | 1 |
Nearside Front Lower Ball joint has excessive play |2.2.B.1f| | 1 |
Exhaust emits an excessive level of metered smoke for a non-turbo charged engine |7.4.B.3b| | 1 |
Registration plate issues | 1 |
Offside Front Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
Rear Exhaust mounting missing |7.1.1b| | 1 |
An item not tested |Manual| | 1 |
Nearside Headlamp not working on main beam |1.7.5a| | 1 |
Offside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
Offside Rear Stop lamp not working |1.2.1b| | 1 |
Front Fuel hose leaking |7.2.3| | 1 |
Offside Stop lamp not working |1.2.1b| | 1 |
Front Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Hazard warning switch faulty |1.4.B.1d| | 1 |
Hazard warning lamps not flashing in phase, with ignition on |1.4.B.1f| | 1 |
Hazard warning lamps not flashing in phase, with ignition off |1.4.B.1f| | 1 |
Nearside Front Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Front Brake master cylinder/servo mounting prescribed area is excessively corroded |3.6.C.3| | 1 |
Nearside Headlamp not in good working order |not working| |1.2.4a| | 1 |
Offside Headlamp not in good working order |not working| |1.2.4a| | 1 |
Nearside Track rod end ball joint has excessive play |2.2.B.1f| | 1 |