| Most common failures | No# failures |
|---|
| Headlamp aim out of alignment | 4 |
| Windscreen washer not working | 3 |
| Windscreen wiper does not clear the windscreen effectively | 3 |
| Offside Stop lamp not working |1.2.1b| | 2 |
| Nearside Headlamp not working on dipped beam |1.7.5a| | 2 |
| Rear parking brake recording little or no effort | 2 |
| Offside Rear fog lamp missing |1.3.2a| | 2 |
| Offside Rear Shock absorber has an excessively worn bush |2.7.4| | 2 |
| Offside Floor excessively deteriorated Floor reinforcement rail (6.2.4 (a) (i)) | 1 |
| Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i)) | 1 |
| Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i)) | 1 |
| Front Drivers seat insecure (6.2.5 (a) (ii)) | 1 |
| Rear fog lamp missing (4.5.1 (a) (ii)) | 1 |
| Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b)) | 1 |
| Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Floor reinforcing panel (6.1.1 (c) (i)) | 1 |
| Offside Rear fog lamp not working |1.3.2b| | 1 |
| Offside Rear reflector missing |1.5.1a| | 1 |
| Nearside Outer Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
| Offside Front wheel bearing rough when rotated |2.5.A.2| | 1 |
| Hazard warning lamps not fitted (4.4.1 (d)) | 1 |
| Parking brake: efficiency below requirements |3.7.B.7| | 1 |
| Nearside Headlamp not working on main beam |1.7.5a| | 1 |
| Nearside Front Direction indicator not working |1.4.A.2c| | 1 |
| Rear fog lamp switch faulty works with main beam not dip beam |1.3.1a| | 1 |
| Nearside Front Axle king pin has excessive play in pin and/or bush adversely affecting the steering lift |2.5.A.3a| | 1 |
| Nearside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
| Offside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
| Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
| Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
| Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
| Nearside Front Body component corroded and likely to cause injury wing (6.2.1 (a) (i)) | 1 |
| Offside Front Body component corroded and likely to cause injury wing (6.2.1 (a) (i)) | 1 |
| Offside Rear fog lamp missing |4.5.1 |a| |ii|| | 1 |
| Offside Rear Service brake effort inadequate at a wheel Possible slight seepage? |1.2.1 |a| |i|| | 1 |
| Horn not working (7.7 (a) (ii)) | 1 |
| Nearside Front Wheel bearing has excessive play (5.1.3 (a) (i)) | 1 |
| Nearside Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
| Offside Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
| Driver`s seat insecure |6.2.A.1| | 1 |
| Rear Loading door cannot be secured in the closed position |6.4.1| | 1 |
| Nearside Loading door cannot be secured in the closed position |6.4.1| | 1 |
| Nearside Headlamp insecure |1.7.3| | 1 |
| Offside Headlamp insecure |1.7.3| | 1 |
| Offside Seat belt retracting mechanism defective (7.1.2 (e)) | 1 |
| Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Front Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Centre Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Rear Exhaust has a part missing |7.1.1a| | 1 |
| Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
| Offside Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
| Offside Rear fog lamp missing (4.5.1 (a) (ii)) | 1 |
| Nearside Front Axle king pin has excessive play in pin and/or bush adversely affecting the steering |2.5.A.3a| | 1 |
| Offside Front Axle king pin has excessive play in pin and/or bush adversely affecting the steering |2.5.A.3a| | 1 |
| Offside Front Front wheel bearing rough when rotated |2.5.A.2| | 1 |
| Exhaust tailpipe not capable of allowing the emission probe to be inserted |7.3.B.1| | 1 |
| Nearside rear brake recording little or no effort |3.7.B.5a| | 1 |
| Offside rear brake recording little or no effort |3.7.B.5a| | 1 |