| Most common failures | No# failures |
|---|
| Brakes imbalanced across an axle | 3 |
| Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i)) | 2 |
| Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i)) | 2 |
| Registration plate lamp issues | 1 |
| Offside Headlamp not working on main beam |1.7.5a| | 1 |
| Offside Stop lamp not working |1.2.1b| | 1 |
| Horn not working |1.6.2a| | 1 |
| Nearside Headlamp not working on main beam |1.7.5a| | 1 |
| Nearside Front Floor excessively deteriorated Small holes floor pan (6.2.4 (a) (i)) | 1 |
| Rear fog lamp missing (4.5.1 (a) (ii)) | 1 |
| Horn not working (7.7 (a) (ii)) | 1 |
| Headlamp aim out of alignment | 1 |
| Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
| Offside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner & outer sill (6.2.2 (d) (i)) | 1 |
| Nearside Front Axle king pin is loose in the axle beam (5.1.2 (d) (i)) | 1 |
| Service brake efficiency below requirements (1.2.2 (a) (i)) | 1 |
| Parking brake efficiency below requirements (1.4.2 (a) (i)) | 1 |
| Nearside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i)) | 1 |
| Offside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i)) | 1 |
| Battery insecure and likely to cause a short circuit (4.13 (a) (ii)) | 1 |
| Nearside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Nearside Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
| Main beam tell-tale not working (4.9.1 (a) (ii)) | 1 |
| Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
| Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
| Windscreen washer not working | 1 |
| Bonnet cannot be secured in the closed position (3.1 (b) (i)) | 1 |
| Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i)) | 1 |
| Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
| Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
| Offside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
| Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |