Most common failures | No# failures |
---|
Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 3 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 3 |
Rear brake binding | 3 |
Windscreen wiper does not clear the windscreen effectively | 2 |
Rear Fuel hose leaking |7.2.3| | 2 |
Brake pipe excessively corroded | 2 |
Headlamp aim out of alignment | 2 |
Offside Rear fog lamp not working |1.3.2b| | 2 |
Horn not working |1.6.2a| | 2 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 2 |
Nearside Front Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
Centre Exhaust system not adequately supported |7.1.1| | 1 |
Front Fuel pipe leaking |7.2.3| | 1 |
Hazard warning switch faulty |1.4.B.1d| | 1 |
Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Centre Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Emissions not tested |7.0| | 1 |
Rear fog lamp tell tale not working |1.3.1b| | 1 |
Rear brake application uneven | 1 |
Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Steering rack gaiter insecure |2.2.D.2d| | 1 |
Brake load sensing valve linkage seized |3.6.E.3| | 1 |
Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Brake hose excessively deteriorated | 1 |
Exhaust emits an excessive level of metered smoke for a non-turbo charged engine |7.4.B.3b| | 1 |
Nearside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Anti-roll bar has excessive play in a pin/bush |2.4.G.2| | 1 |
Offside Rear Body has a sharp edge caused by damage |6.1.C.1| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Nearside Rear Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Nearside Rear Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Offside Rear Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Mechanical brake component has restricted free movement | 1 |
Offside Front An item not tested |Manual| | 1 |