Most common failures | No# failures |
---|
Registration plate lamp issues | 6 |
Windscreen wiper does not clear the windscreen effectively | 3 |
Offside Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 3 |
Brakes imbalanced across an axle | 2 |
Offside Lower Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 2 |
Nearside Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 2 |
Headlamp aim out of alignment | 2 |
Offside Rear Stop lamp adversely affected by the operation of another lamp |1.2.1f| | 2 |
Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Offside Seat belt locking mechanism does not secure or release |5.2.5a| | 1 |
Nearside Lower Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Lower Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Lower Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Front brake application uneven | 1 |
Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 1 |
Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone `A` |8.3.1e| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Side repeater not working |1.4.A.2c| | 1 |
Rear brake binding | 1 |
Offside Rear Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Front Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Nearside Front Service brake excessively binding (1.2.1 (f)) | 1 |
Offside Front Service brake excessively binding (1.2.1 (f)) | 1 |
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i)) | 1 |
Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) | 1 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Rear Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Nearside Front Steering rack gaiter split |2.2.D.2d| | 1 |
Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement |7.2.4b| | 1 |
Nearside Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
Rear Brake load sensing valve linkage seized |3.6.E.3| | 1 |
Offside Obligatory mirror seriously damaged, affecting the rear view |8.1.2a| | 1 |
Offside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Stop lamp not working |1.2.1b| | 1 |
Nearside Rear Stop lamp not working |1.2.1b| | 1 |
Offside Rear Stop lamp not working |1.2.1b| | 1 |
Front passenger door cannot be opened from inside the vehicle |6.2.B.1b| | 1 |
Front passenger door cannot be opened from outside the vehicle |6.2.B.1b| | 1 |
Nearside Front Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |