Most common failures | No# failures |
---|
Headlamp aim out of alignment | 3 |
Parking brake: efficiency below requirements |3.7.B.7| | 3 |
Nearside Stop lamp not working |1.2.1b| | 2 |
Windscreen wiper does not clear the windscreen effectively | 2 |
Offside Stop lamp not working |1.2.1b| | 2 |
Exhaust has a major leak of exhaust gases |7.1.2| | 2 |
Brakes imbalanced across an axle | 2 |
Registration plate lamp issues | 2 |
Direction indicators flashing less than 60 times a minute |1.4.A.2g| | 1 |
Offside Rear wheel cylinder leaking |3.6.A.1| | 1 |
Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Steering system has excessive free play detected at the steering wheel |steering box fitted| |2.2.A.1a| | 1 |
Rear Mechanical brake component has restricted free movement | 1 |
Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Direction indicators not working |1.4.A.2c| | 1 |
Hazard warning lamps not flashing in phase, with ignition on |1.4.B.1f| | 1 |
Hazard warning lamps not flashing in phase, with ignition off |1.4.B.1f| | 1 |
Hazard warning tell tale not working correctly |1.4.B.1e| | 1 |
Offside Windscreen wiper not operating automatically when switched on |8.2.1b| | 1 |
Offside Front Axle king pin has excessive play in pin and/or bush adversely affecting the steering |2.5.A.3a| | 1 |
Front brake application uneven | 1 |
Nearside Windscreen wiper not operating automatically when switched on |8.2.1b| | 1 |
Dipswitch operation does not deflect all main beam headlamps to make them dipped beams |1.7.4b| | 1 |
Indicator tell tale inoperative |1.4.A.2a| | 1 |
Offside rear brake recording little or no effort |3.7.B.5a| | 1 |
Offside Front Direction indicator not working |1.4.A.2c| | 1 |
Offside Rear Direction indicator not working |1.4.A.2c| | 1 |
Nearside Front Seat belt insecurely fixed to the vehicles structure |5.2.1a| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
Nearside Front Mechanical brake component locking device insecure |3.5.1l| | 1 |
Offside Front Mechanical brake component locking device insecure |3.5.1l| | 1 |
Registration plate issues | 1 |
Offside Rear Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
Nearside Front Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 1 |
Offside Front Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 1 |
Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Nearside Front wheel bearing rough when rotated |2.5.A.2| | 1 |
Offside Front wheel bearing rough when rotated |2.5.A.2| | 1 |
Offside Front wheel bearing has excessive play |2.5.A.3c| | 1 |
Fuel system component leaking engine area |7.2.3| | 1 |