Most common failures | No# failures |
---|
Parking brake: efficiency below requirements |3.7.B.7| | 7 |
Rear parking brake recording little or no effort | 4 |
Brake hose excessively deteriorated | 4 |
Registration plate lamp issues | 4 |
Horn not working |1.6.2a| | 3 |
Brake pipe excessively corroded | 3 |
Rear brake binding | 3 |
Brakes imbalanced across an axle | 2 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Rear Exhaust has a major leak of exhaust gases |7.1.2| | 2 |
Nearside Front Position lamp not working (4.2.1 (a) (ii)) | 2 |
Nearside Front Steering rack gaiter split |2.2.D.2d| | 2 |
Nearside Stop lamp not working |1.2.1b| | 2 |
Offside Stop lamp not working |1.2.1b| | 2 |
Headlamp aim out of alignment | 2 |
Exhaust has a major leak of exhaust gases |7.1.2| | 2 |
Offside Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 1 |
Offside Subframe mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
Nearside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Fuel pipe insecure |7.2.1| | 1 |
Offside Rear Radius arm locating pin insecure |2.4.G.3a| | 1 |
Offside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
Nearside Steering rack damaged and unserviceable |2.2.C.1d| | 1 |
Offside Fluid suspension supply pipe insecure |2.4.D.3| | 1 |
Offside Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone `A` |8.3.1b| | 1 |
Hazard warning switch faulty |1.4.B.1d| | 1 |
Hazard warning tell tale not working correctly |1.4.B.1e| | 1 |
Nearside Front Seat belt retracting mechanism defective |5.2.5b| | 1 |
Nearside Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
Hazard warning lamps not flashing in phase, with ignition on |1.4.B.1f| | 1 |
Hazard warning lamps not flashing in phase, with ignition off |1.4.B.1f| | 1 |
Windscreen washer not working | 1 |
Offside Headlamp aim does not move downwards when dipped |British American headlamp| |1.8.C.4| | 1 |
Lower Steering column universal joint insecure |2.1.5| | 1 |
Nearside Outer Front Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
Offside Front Steering rack insecure |2.2.B.1a| | 1 |
Nearside Front Upper Front suspension ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
Nearside Front Lower Front suspension ball joint dust cover missing |2.4.G.2| | 1 |
Nearside Suspension component mounting prescribed area is excessively corroded floor to sill |2.4.A.3| | 1 |
Offside Suspension component mounting prescribed area is excessively corroded sill |2.4.A.3| | 1 |
Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Nearside front brake binding |3.7.B.1| | 1 |
Nearside Front wheel bearing rough when rotated |2.5.A.2| | 1 |
Nearside Suspension component mounting prescribed area is excessively corroded front and rear sill to floor |2.4.A.3| | 1 |
Nearside Rear Radius arm attachment bracket/mounting bolt missing |2.4.G.1| | 1 |
Headlamp not working on main beam both |1.7.5a| | 1 |
Stop lamp not working both |1.2.1b| | 1 |
Stop lamp not working Both |1.2.1b| | 1 |
Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Centre Exhaust system not adequately supported |7.1.1| | 1 |
Nearside Direction indicators flashing more than 120 times a minute |1.4.A.2g| | 1 |
Rear Exhaust mounting missing |7.1.1b| | 1 |
Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Windscreen wiper does not clear the windscreen effectively | 1 |
Offside Direction indicators flashing less than 60 times a minute |1.4.A.2g| | 1 |
Nearside Front Suspension arm rubber bush deteriorated resulting in excessive movement bottom arm |2.4.G.2| | 1 |
Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Horn not working (7.7 (a)) | 1 |
Nearside Headlamp not working on main beam |1.7.5a| | 1 |
Offside Headlamp not working on main beam |1.7.5a| | 1 |
Nearside Front Passenger`s seat insecure |6.2.A.1| | 1 |
Steering rack insecure offside end of rack |2.2.B.1a| | 1 |
Central Exhaust system not adequately supported |7.1.1| | 1 |
Parking brake efficiency below requirements (1.4.2 (a) (i)) | 1 |
Nearside Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 1 |
Offside Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
Front Suspension component mounting prescribed area is excessively corroded CROSS MEMBER |2.4.A.3| | 1 |
Nearside Front Suspension component mounting prescribed area is excessively corroded FLOOR |2.4.A.3| | 1 |
Nearside Front Front wheel bearing rough when rotated |2.5.A.2| | 1 |
Front Exhaust has a major leak of exhaust gases (6.1.2 (a)) | 1 |
Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
Nearside Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i)) | 1 |
Offside Rear Braking system leaking |3.6.A.1| | 1 |
Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i)) | 1 |
Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced floor (7.1.1 (a) (i)) | 1 |
Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced floor (7.1.1 (a) (i)) | 1 |
Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wing tie rod mounting (5.3.6 (a) (i)) | 1 |
Nearside Front Windscreen wiper blade deteriorated |8.2.2| | 1 |
Offside Front front brake binding |3.7.B.1| | 1 |
Exhaust system not adequately supported |7.1.1| | 1 |
Nearside Front Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Headlamp not working on dipped beam |1.7.5a| | 1 |
Power steering component|s| leaking |2.3.3b| | 1 |
Nearside Front Headlamp not working on dipped beam |1.7.5a| | 1 |
Offside Front Headlamp not working on dipped beam |1.7.5a| | 1 |
Exhaust has part of the system excessively deteriorated |7.1.1a| | 1 |
Front Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Nearside Front Sub-frame corroded and seriously weakened |2.4.G.1| | 1 |
Offside Front Sub-frame corroded and seriously weakened |2.4.G.1| | 1 |