Most common failures | No# failures |
---|
Headlamp aim out of alignment | 88 |
Registration plate issues | 26 |
Windscreen wiper does not clear the windscreen effectively | 18 |
Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h)) | 13 |
Windscreen washer not working | 5 |
Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c)) | 4 |
Nearside Front Service brake excessively fluctuating (1.2.1 (e)) | 2 |
Headlamp cleaning device for LED or HID headlamp inoperative (4.1.6 (a) (ii)) | 2 |
Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturers specified limits (8.2.1.2 (a)) | 2 |
Brake lever pivot has excessive wear or free play (1.1.1 (b)) | 1 |
Offside Front Headlamp not working on dipped beam |4.1.1 |a| |ii|| | 1 |
Nearside Rear Stop lamp(s) not working Flickering on/off (4.3.1 (a) (ii)) | 1 |
Nearside Rear Parking (secondary brake) on a single line braking system has inadequate effort at a wheel (1.3.1 (a) (i)) | 1 |
Parking brake efficiency below requirements (1.4.2 (a) (i)) | 1 |
Fuel cap/sealing device ineffective (6.1.3 (b) (i)) | 1 |
Engine MIL inoperative or indicates a malfunction |8.2.1.2 |h|| | 1 |
Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
Offside Rear Position lamp with a multiple light source more than 1/2 not functioning (4.2.1 (a) (ii)) | 1 |
Nearside Rear Service brake excessively binding (1.2.1 (f)) | 1 |
Offside Rear Service brake excessively binding (1.2.1 (f)) | 1 |
Offside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
Front Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a)) | 1 |
Registration plate lamp issues | 1 |
Bonnet cannot be secured in the closed position (3.1 (b) (i)) | 1 |
Nearside Front Brake hose excessively damaged Feral breaking up (1.1.12 (b) (ii)) | 1 |
Offside Front Seat belt damaged (7.1.2 (b) (i)) | 1 |
Offside Front Service brake excessively fluctuating (1.2.1 (e)) | 1 |
Nearside Front Road wheel fractured (5.2.2 (a)) | 1 |
Offside Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
Offside Seat belt anchorage prescribed area strength or continuity significantly reduced on sill (7.1.1 (a) (i)) | 1 |
Offside Rear Suspension component mounting prescribed area excessively damaged significantly reducing structural strength on sill (5.3.6 (a) (i)) | 1 |
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength on sill (5.3.6 (a) (i)) | 1 |
Nearside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected suspension arm mounting point (5.3.6 (a) (ii)) | 1 |
Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b)) | 1 |
Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b)) | 1 |
Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturers specified limits (8.2.1.2 (a)) | 1 |
Exhaust carbon monoxide content at idle exceeds manufacturers specified limits (8.2.1.2 (b)) | 1 |
Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) | 1 |
Reversing lamp inoperative (4.6.1 (a)) | 1 |